I started a video-series about a “not so easy” topic. Toolchangers!
Producing this type of content is extremely time consuming and difficult. Also, it doesn’t “pay by itself” because of the topic being a real niche – and therefore without many viewers. Additionally, I do pay for most of the stuff by myself.
If you find these tutorials helpful, consider supporting me via Patreon or treat me to a beer via: paypal.me/renejurack – it means a lot for me!
Check out the steadily growing playlists below:
SEASON 1: ASSEMBLY
Subscribe for updates!
E3D Toolchanger – Assembly #01 – The Motionsystem
E3D Toolchanger – Assembly #02 – Electronics
E3D Toolchanger – Assembly #03 – Heated Bed & Grounding
E3D Toolchanger – Assembly #04 – bowden-V6&Volcano
E3D Toolchanger – Assembly #05 – Toolhead
E3D Toolchanger – Assembly #06 – Mains Wiring
E3D Toolchanger -Assembly #07 – Connecting Motors & Tools
E3D Toolchanger – Assembly #08 – Spools & Brushes
E3D Toolchanger – Assembly #09 – Hemera Tools
SEASON 2: CONFIGURATION
E3D Toolchanger – Configuration #01 – Initial Setup
E3D Toolchanger – Configuration #02 – Adjusting Z-offsets
E3D Toolchanger – Configuration #03 – Adjusting X&Y-offsets
E3D Toolchanger – Configuration #04 – Adjusting Hemera Tools
SEASON 3: SLICING & SCRIPTING
Toolchanger – Slicing #01 – S3D Basics
SEASON 4: UPGRADES
E3D Toolchanger – UPGRADES #01 – automatic adjusting brush
E3D Toolchanger – UPGRADES #02 – double PSU
E3D-Toolchanger – Pen Tool